QSC8.3 and QSL9 Cummins®/Fleetguard® Filter Specifications Section V - Maintenance Specifications Page V-5 1 This filter is designed for service intervals up to 40,234 km [25,000 miles] when using TMC RP329/RP330 or ASTM D6210 coolants that meet Cummins® Engineering Standard CES 14603. The filter is designed for cooling systems up to 45 liters [12 gallons]. Refer to Cummins® Coolant Requirements and Maintenance, Bulletin 3666132. If the coolant system capacity is greater than 45 liters [12 gallons], one unit of chemical per 3 system gallons is required for adequate system treatment.
If needed, contact Cummins Filtration™ (Toll Free - (800) 223-4583)) for other coolant filter options for different size cooling systems. 2 This filter has been designed for extended service intervals of 80,467 to 241,402 km [50,000 to 150,000 miles]. It has no chemical additives, as it contains zero units of DCA4. When using the WF2123 filter, the appropriate volumes of liquid treatment must be added at the designated distances/intervals. For a 25,000 mile service interval with RP329/RP330 coolants, one pint of DCA4 (or DCA2) liquid treatment should be added for cooling systems that do not exceed 45 liters [12 gallons].
For a 150,000 mile service interval with ES Compleat™ Coolant (ES Extender Liquid), one quart of this liquid treatment should be added for cooling systems that do not exceed 45 liters [12 gallons]. NOTE: An LF9009 lubricating oil filter must be used. A venturi type lubricating oil filter must be used in order to benefit from the bypass filtration section of the lubricating oil filter. Do not use an LF3000 lubricating oil filter. Engine durability will be reduced by the use of the wrong lubricating oil filter.
Filter Part Numbers (All Applications Except Marine) - Coolant Filter Water-separating Filter Fuel Filter Lubricating Oil Filter Cummins Filtration™ Part Number WF20711, WF21232 FS1003 FF5488 LF9009