1. Introduction In the EDC systems, it is very important to ensure correct connection between the sensors and actuators on the one hand and the control unit on the other. This is achieved by means of a wiring harness. The system may fail and functions can be impaired if the plug connections and electrical lines are not selected and connected correctly in accordance with specifications. Malfunctions with their cause in the wiring harness are very difficult to locate, making subsequent inspection and rectification intricate and expensive. Wiring harness and plug connection failures which remain undetected are often mistakenly attributed to unit/component failures. 2.
General The EDC wiring harness is subject to particular requirements with regard to design and environ- mental influences to ensure it does not interfere with the EDC functions. Individual customer standards are not restricted by this guideline, but rather they are used as the basis for general wiring harness manufacture. Information is only provided on lines which belong to the EDC system. The relevant system connector drawings and terminal connection diagrams serve as the basis for wiring harness manufacture. They are compiled specifically for every new EDC system.
The connector drawing with parts list (Annex 1) represents the scope of delivery of the plug con- nectors used, indicates what wire cross sections are used and where individual connection points are to be planned. The terminal connection drawing with control unit connector assignments (Annex 2) shows in schematic form the connection between control units and actuators as well as sensors. It also indicates what wires are to be shielded or twisted. When assessing a system, the vehicle must be examined for possible irradiation and emission in an electromagnetic compatibility (EMC) test bay with a standard wiring harness.
Measures for the purpose of galvanic, capacitive and inductive decoupling must be implemented to ensure high EMC-specific interference immunity is achieved. Some of these measures are: Isolation of power circuits from sensor lines by separate cable routing Avoiding routing wires subject to pulses and sensor wires in parallel Shielding of cables and wires Twisting wires in pairs If possible, maintaining distance between wires and cables of different systems 3. Plug connectors and sockets Blade and pin terminal plugs are used as the connection elements in EDC systems. Refer to the wir- ing harness drawing (Annex 1) for the plug connectors used in the relevant project.
Any customer- specific plug connectors to be used should be checked in accordance with Bosch connector specifi- cations. Zinc, silver and gold are used as contact materials. The same materials should always be used for the PIN and socket. D Mounting contacts in connector housings: The notes on design and assembly (Annex 3) should be used as the basis for producing con- nectors and wiring harnesses. 121