Notes on design and assembly for wiring harnesses of electronic systems A. Manufacture 1. Contacts 1.01 Contact material : Tin bronze Surface : Tinned 1.1 All contacts must be fitted in the correct position in the chambers and locked in a floating arrange- ment in the connector housings. Optionally, the contacts can be fitted turned through 180 degrees in the 2-pin to 7-pin connector housings with manual release and not featuring options for ultrasonic caulking (see Page 5). 1.2 Careful handling of the contacts is necessary Protection against damage is not provided before being fitted in the connector housing. Damaged contacts: Contact points bent Latching springs bent must not be used.
1.3 The specified additional latching elements must be used on multiple connector housings. 2. Line and insulation crimping must take place together with the correct tools. Particular care must be taken to ensure that the fixing tool and the contact match the reduced insulation thickness. 2.1 Withdrawal force of individual conductor out of the crimp connection: 1.0 mm 2 min. 160 N 1.5 mm 2 min. 200 N 2.5 mm 2 min. 250 N 4.0 mm 2 min. 350 N 6.0 mm 2 min. 500 N 3. There must be no insulation in the conductor crimping. 4. The conductor must be crimped over the entire connection point. 4.1 Protruding individual wires only in permissible area (not up to contact point). 5.
Insulation crimping of the lines must be continuous (important as protection against bending and as strain-relief). 5.1 The insulation must be crimped over the entire connection point. 6. Cable shoes which are not capable of being crimped must be additionally soldered after connection. The insulation must not be damaged. 6.1 Additionally solder crimp connection if specified in the drawing. 7. Insulating sleeves must be firmly interconnected at the branch points. Length of overlap approx. 20 mm 7.1 The transition point must be tightly bonded. 8. The insulating sleeves must be fitted in the rubber grommets up to approx. 20 mm. 8.
The insulator sleeve must be secured with the clip on 15-pin, 25-pin, 35-pin, 55-pin and 88-pin con- nector housings (strain relief). 10. Folds and creases in the diameter between the insulating tube and rubber grommet are not per- mitted. 11. Protective caps must be fitted in the connector housing. 131