STRUCTURE AND FUNCTION ELECTRONIC CONTROL SYSTEM Control method in each mode Heavy-duty operation (H/O) mode Matching point in heavy-duty operation mode: 96% partial output point When the load on the pump rises and the pres- sure rises, the engine speed goes down. When this happens, the pump discharge amount is reduced, and the engine speed is controlled so that it becomes near the 96% partial output point. If the reverse happens and the pressure goes down, the system is controlled so that the pump discharge amount is increased until the engine speed becomes near the 96% partial output point. By repeating this control, the engine can al- ways be used at near the 96% partial output point.
When the load on the pump rises and the pres- sure rises, the engine speed goes down. When this happens, mutual control of the engine and pump is used to control the system so that the pump absorption torque follows the equal horsepower curve of the engine, and the en- gine speed is lowered while keeping the torque constant. In this way, the engine is used in a range which provides good fuel efficiency. 10-141 Model Mode PC210-6K PC240-6K Heavy-duty operation (H/O) 96 kW/1,800 rpm 128 HP/1,800 rpm 114 kW/2,000 rpm 153 HP/2,000 rpm General operation (G/O), finishing operation (F/ • Matching point in general operation, finishing operation, and breaker operation mode:
80% partial output point Model Mode PC210-6K PC240-6K General operation (G/O), finishing operation (F/O), breaker operation (B/O) 81 kW/1,700 rpm 108 HP/1,700 rpm 96 kW/1,800 rpm 128 HP/1,800 rpm