Komatsu — C- 20 [E227] Abnormality in engine speed sensor system is displayed

TROUBLESHOOTING C-MODE C-20 [E227] Abnormality in engine speed sensor system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check is an E service code is displayed. (If it is not displayed, the problem had been removed). # Before carrying out troubleshooting, check that all related connectors are properly inserted.

# Always connect any disconnected connectors before going on the next step. C-20 Related electric circuit diagram Engine throttle pump controller 20-194 2 YES Is resistance YES between C16 1 (female) (1) and (2) normal Is resistance • Turn starting switch NO between E07(male) OFF. (1) and (2) normal • Disconnect C16. • 500 - 1000  • Turn starting switch OFF. NO • Disconnect E07.

• 500 - 1000  Cause Remedy Defective engine throttle - pump controller Short circuit with ground, defective contact, or disconnection in wiring harness between C16 (female) (1) - E08 (10) - E07 (female) (2), or between C16 (female) (2) - E08 (9) - E07 (female) (1) Defective engine speed sensor (internal disconnection, defective contact, or short circuit with ground) Replace Repair or replace Replace