Komatsu — F- 1 Bit pattern 20 - (1) Swing oil pressure switch does not light up

TROUBLESHOOTING F-MODE TROUBLESHOOTING OF ENGINE THROTTLE • PUMP CONTROLLER (INPUT SIGNAL SYSTEM) (F MODE) F-1 Bit pattern 20 - (1) Swing oil pressure switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. Turn swing lock switch ON before operating the swing lever. # If there is no display when the lever is operated on one side, the PPC shuttle valve is defective.

(See H-5) (When measuring with the engine stopped, charge the accumulator first). *! Before carrying out trouble- shooting, check that all related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. operated: Max. 1 q See Note 1. Note 1: It is also possible to fit a short connector and judge the condition. In this case, check the voltage be- tween C16 (5) and the chassis. If it is 20-30 V: go to YES If it is less than 1V: Go to NO F-1 Related electric circuit diagram Engine throttle pump controller 20-195 YES 1 3 YES Is voltage between C16 (5) and chassis Is resistance between normal?

YES C16 (female) (5) and S08 (female) (2) nor- 2 mal, and is circuit in- • Start engine Is resistance be- sulated from chassis? • Swing lever at neutral tween S08 (male) (1) • Turn starting switch NO • : S 2 w0 in - g 3 l0 e vV er NO a isn cd i r( c2 u) i tn io nr sm ula al t, e a dnd • O DiF sF c. onnect C16 and S08. operated from chassis? • Between C16 and S08: Max. 1q : Max. 1V • Disconnect S08. • Between wiring harness and chassis: No continuity • Start engine. NO • Swing lever at neutral : Min.

1Mq • Swing lever Cause Remedy Defective engine throttle - pump controller Defective contact, or disconnection in wiring harness between S08 (female) (1) and chassis ground Defective contact, short circuit with ground, or disconnection in wiring harness between C16 (female) (5) and S08 (female) (2) Defective swing oil pressure switch (If the condition does not return to normal even when the switch is replaced, go to H-5. Replace Repair or replace Repair or replace Replace