Freightliner — Freightliner Business Class M2 Workshop Manual

Hydraulic Brake System, Bosch 42.15 Troubleshooting Verify condition: Remove the fill cap from the master cylinder. Look at the diaphragm inside the cap. Is the diaphragm swollen? See Figure 7. 1. With engine OFF, measure location of the pedal from the floor. 2. Start engine and measure if pedal dropped to a new position. 3. Shut OFF engine and determine whether pedal returned to original position. − Smoking? − Over heating? − Smell? − Pulling? − Poor acceleration? No Did pedal drop about 1/2−inch (12mm) when engine started? Yes See Figure 6. Yes No Caliper assembly is probably dragging on its pins or rails. The caliper housing may not be sliding freely in anchor plate.

Apply and release the brakes, then loosen one of the caliper bleed scr− ews within a few seconds. Does fluid flow out under pressure? Perform the check on all wheel ends. Then tighten tube nuts to specification after each check. The master cylinder has been contaminated with the wrong fluid. Re− place all of the following: the master cylinder, all calipers, the ABS valve, and all rubber hoses. Flush the steel brake tubes with clean brake fluid prior to at− taching new rubber hoses. No Yes The problem is probably with the booster, master cylinder, or ABS. See Figure 14. Remove shoe pads and reassemble the caliper without shoe pads. Slide caliper inboard to outboard by hand.

Does caliper move freely? Yes The problem is probably with the pistons in the caliper. Repair or replace the caliper. See the appropriate brake section in this manual. No The problem is probably with the pins if equipped with pin slide brakes. Repair or re− place pins and/or anchor plate. If the vehicle has rail slide brakes, the problem is probably with the rails. Clean and lubricate the rails. See appropriate section of the service manual. 04/23/2003 f040631 Fig. 13, Flow Chart: Brakes are Dragging Business Class M2 Workshop Manual, Supplement 17, March 2010 300/12