Batteries 54.03 Troubleshooting they are going to last only two days before causing a no-start condition. 11. Wait at least 60 seconds, then check the current reading. If the current reading is at or below 2 amps, close the drain tool (to maintain continuity in the electrical system) and switch down to the 2-amp scale for a more accurate reading when the drain tool is re-opened. Important: If the batteries begin storage at 90 percent of full charge, reduce the available ampere-hours accordingly. Battery Electrical Drain and Parasitic Load Test 12. The ECU/BHM/CHM/ABS current draw should be less than 325 mA with no circuits active.
The fol- lowing measurement reflects the value of the current draw with all systems off. If the batteries in a vehicle become discharged in a shorter time than described earlier, the vehicle may have a parasitic load that is out of specification. Refer to the instructions in this subject to determine the source of parasitic loads. A measurement below 325 mA indicates that the ECU/BHM/CHM/ABS is OK. A measurement above 325 mA indicates a possible problem with the ECU/BHM/CHM/ ABS. Disconnect each component and re- check the current draw as directed. A J38758 Parasitic Draw Test Switch (available from Kent-Moore) and a digital multimeter set to the 10A scale is required for this test.
Before performing the load test, ensure that the fol- lowing conditions are met: A measurement significantly over 325 mA indicates a problem unrelated to the ECU/ BHM/CHM/ABS. the ignition key is out of the ignition; A measurement of approximately 0 amps indicates a faulty ECU, BHM, CHM, or ABS. all doors are closed; the headlights and park lights are off; 13. Repeat the parasitic current drain procedure after any repair is completed. the courtesy lights are off; The batteries are fully charged. 14. Remove the drain test tool and reconnect the negative battery cable. 1. With the vehicle parked, apply the parking brakes, and shut down the engine. 15. Remove the chocks from the tires. 2.
Disconnect the cable from the negative battery terminal. 3. Install the drain test tool, with the male end con- nected to the negative battery terminal. 4. Turn the draw test tool to the open position. 5. Attach the negative battery cable to the female end of the drain test tool. 6. Turn the drain test tool to the closed position. 7. Road test the vehicle while activating all acces- sories. 8. Shut down the engine and remove the ignition key. 9. Set the ammeter to the 10-amp scale and con- nect to the terminal on the drain test tool. 10. Turn the drain tool to the open position to allow current to flow thorough the ammeter. Business Class M2 Workshop Manual, Supplement 11, March 2007 300/3