Freightliner — Freightliner Business Class M2 Workshop Manual

Body Builder Lighting Interfaces 54.35 Specifications Current Capabilities Circuit Identification The high-current lighting interface harness supplies 20-amp circuit protection on all outputs. The Chassis Module (CHM) controls relays located in the taillight power distribution module (PDM). The PDM also contains fuses to provide the 20-amp circuit protec- tion when the relays are activated. Battery power to the taillight PDM fuses is supplied from one of the MEGA ® Fuses. Chassis Module The Chassis Module (CHM) may be located on a bracket behind the back-of-cab crossmember (stan- dard location), or underneath the cab on the driver’s side. For the back-of-cab CHM location, see Fig. 5 .

For CHM connector identification, see Fig. 6 . The high-current and low-current interface harnesses receive CHM lighting outputs via CHM connector C1. For a connector face view and pinout chart of the CHM C1 connector, see Table 1 . The low-current lighting interface harness provides outputs that are essentially splices from existing CHM lighting signals. The low-current interface har- ness provides for limited load applications such as additional LED (light-emitting diode) lighting. Since the interface outputs are splices from existing cir- cuits, CHM maximum current loads can not be ex- ceeded.

Most of the CHM lighting outputs support a maximum current load of 7.45 amps, with the excep- tion of the taillight outputs which support a combined maximum current load of 1 amp. When determining the total combined current load for any output, in- clude the new lighting connected to the interface as well as all preexisting lighting of the same function that came factory-installed and is not permanently removed during body installation. The marker light jumper harness is inserted at pin M of the CHM connector C4. For a connector face view of the CHM C4 connector and pin M identification, see Table 2 . The marker light junction block connection is made at pin F of the CHM connector C2.

For a connector face view of the CHM C2 connector and pin F identi- fication, see Table 3 . Taillight PDM The taillight power distribution module (PDM) con- tains the necessary components to supply a high- current lighting interface harness. For taillight PDM layout and identification of electrical connections, see Subject 100 . Additional marker light connections are powered by a CHM output. Do not exceed a maximum combined current load of 10 amps for a CHM marker lights out- put. When installing any additional marker lights, in- clude an inline fuse with a rating equal to, or slightly higher than, the added lighting load. In no instance should the inline fuse exceed 10 amps.

For a connector face view and pinout chart of the taillight module harness PDM connector C2, see Table 4 . Lighting Interface Wiring Diagrams For a connector face view and pinout chart of the lighting interface harness PDM connector C8, see Table 5 . Lighting Interface For a wiring diagram of the original design for the high-current interface harness A06-44608, see Fig. 1 . For a connector face view and pinout chart of the original design for the high-current lighting interface harness A06-44608, see Table 6 . For a wiring diagram of the new design for the high- current interface harness A06-48218, see Fig. 2 .

For a connector face view and pinout chart of the new design for the high-current lighting interface har- ness A06-48218, see Table 7 . For a wiring diagram of the low-current interface har- ness A06-44388, see Fig. 3 . For a wiring diagram of the additional marker lights, see Fig. 4 . For a connector face view and pinout chart of the low-current lighting interface harness A06-44388, see Table 8 . Business Class M2 Workshop Manual, Supplement 13, March 2008 400/1