Body Builder Engine Interfaces 54.36 Engine Cruise Control Harness Installation Installation IMPORTANT: Check the pin locations to verify the proper location. 1. Turn off the engine, apply the parking brakes, and chock the tires. 9. Connect wires 440G to any open cavity on splice pack 13. See Fig. 2 for a wiring diagram for a vehicle without an optional access connector for the engine control module (ECM); see Fig. 3 for a wiring diagram for a vehicle with an optional access connector for the ECM (sales codes 148- 014 through 148-046). NOTE: The cavity locations may vary based on the vehicle configuration. 2.
Disconnect the negative leads from the batteries or, if the vehicle is equipped with a battery dis- connect switch, turn the switch to the off position. 3. Remove the dash surround bezel, passenger- side dash cover, dash top cover, center dash panel, and left-side auxiliary control panel. See Section 60.08 for removal instructions. 4. Disconnect the cruise control switches from the main dash electronic control unit (ECU) harness. 10. Connect wire 81C to any open cavity on splice pack 12A. 5. Remove the cruise control switches from the dash panel. 11. Connect wire 1204 GND to any open cavity on splice pack 9. 5.1 From behind the dash panel, depress the clips that hold the switch in place. 12.
Connect wire 29A to any open cavity on splice pack 1. 5.2 With the clips depressed, push the switch out through the front of the dash panel. 13. On a vehicle without an optional access connec- tor for the ECM, connect wire 440E to pin 4 of connector VC3 on the dash ECU harness. See Fig. 2 . 5.3 Repeat these substeps for the other switch. 13.1 Connect wire 440F to pin 5 of connector VC3 on the dash ECU harness. 6. Tape the dash harness connectors so they do not rattle. NOTE: The connectors will not be used again, but there is no need to remove them. 13.2 Connect wire 440D to pin 6 of connector VC3 on the dash ECU harness. 14.
On a vehicle with an optional access connector for the ECM, locate the 6-pin connector near the vehicle control unit (VCU). The 6-pin connector has an empty mating connector with wires 439U, 439A, and 439B. See Fig. 3 . 7. Install the new cruise control switches in the dash panel by pushing them in from the front of the dash panel until they click into place. See Table 1 for part numbers of the cruise control switches and the engine cruise control harness. NOTE: There may be additional wires de- pending on the vehicle configuration. Parts Required Description Part Number Qty. 14.1 Unplug the mating connector and insert wire 440D in cavity 1, 440E in cavity 2, and 440F in cavity 3.
On-Off Cruise Control Switch A06-30769-011 1 Set-Resume Cruise Control Switch A06-30769-012 1 14.2 Plug the mating connector into the vehicle-side 6-pin connector. Cruise Control Harness A06-47841-000 1 Table 1, Parts Required 15. Install the dash panels. See Section 60.08 for installation instructions. 16. Connect the batteries or turn the battery discon- nect switch to on. 8. Connect the engine cruise control harness (A06- 47841-000) to the cruise control switches, and route the harness over the main dash ECU har- ness. See Fig. 1 . 17.
Using a Minidiag or DDDL, set the following pa- rameters so that the cruise control switches will Business Class M2 Workshop Manual, Supplement 10, September 2006 100/1