Chassis Electrical Control Systems 54.40 General Information Background Information axles spin equally and improve traction by turning all rear wheels at the same speed. Chassis electrical control systems are optional fea- tures on a Business Class ® M2 vehicle. These fea- tures include: NOTE: Operating the vehicle with the interaxle lock activated under normal driving conditions increases driveline and tire wear. The interaxle lock should be used only when improved trac- tion is needed.
interaxle lock axle shift suspension dump Interaxle Lock Controls fifth wheel slide tag/pusher axle lift With the engine running, the interaxle lock can be activated using a momentary, two-position smart switch. Press the upper half of the interaxle lock switch to activate the interaxle lock. Press the upper half of the interaxle lock switch again to deactivate the interaxle lock. See Fig. 1 . If the interaxle lock is activated and the engine is then turned off, the sys- tem will deactivate the interaxle lock. differential lock The chassis electrical control systems are similar in their electronic operation and control. Most of these systems are activated by dash-mounted smart switches.
Smart switches contain internal resistors that com- municate switch identification, location, function, and activation positions. Smart-switch signals are sent directly to the Bulkhead Module (BHM). The BHM reads the smart-switch resistor codes and communi- cates the necessary signals that request system op- eration. Each smart switch is equipped with two light-emitting diodes (LED). One LED provides switch illumination while the other indicates when the switch is on and the system is activated. For more information con- cerning smart switches, see Section 54.14 . 10/26/2001 f610595 The BHM transmits system control requests via the J1939 data line to the Chassis Module (CHM).
The CHM uses low-current outputs and digital inputs to control and monitor the different chassis electrical control systems. Fig. 1, Interaxle Lock Switch When the interaxle lock switch is activated, the CHM transmits a low-current output to a normally closed air management unit (AMU) solenoid. On auxiliary air valve assembly (AAVA) vehicles, the solenoid current is about 1.5 amps. The 2010 CHM does not have the current sourcing ability to drive these solenoids, so a relay in the chassis PDM is added to the circuit. The energized AMU/AAVA solenoid opens and supplies compressed air to the forward rear axle differential housing.
The air sent to the housing applies a lock to the interaxle differential causing all driveline torque to be shared equally by the rear axles. Interaxle Lock The interaxle lock is available on a vehicle with a tandem axle or a tri-drive axle. When activated, the interaxle differential is locked. This essentially makes the driveshaft a solid connection between the rear axles. Power entering the forward axle is transmitted straight through to the rear axle. Driveline torque is now delivered equally between the rear drive axles.
In slippery conditions, without the interaxle lock acti- vated, one drive axle receives the majority of the driveline torque when its wheels lose traction; how- ever, with the interaxle lock activated, the rear drive Feedback from the AMU/AAVA solenoid is required for correct operation of the interaxle lock controls. Feedback is provided by a ground input to the CHM. The ground input is delivered when the pressure switch closes. On AAVA-equipped vehicles, the pres- sure switch is in the air line. On AMU equipped ve- hicles, the pressure switch is in the AMU module. A Business Class M2 Workshop Manual, Supplement 22, September 2012 050/1