Freightliner — Freightliner Business Class M2 Workshop Manual

Chassis Electrical Control Systems 54.40 General Information ECM. For other engine configurations, the system controls a relay that provides a ground input as the ECM feedback. With the system set for low range, the relay coil receives no power and a ground input is provided to the ECM through the closed switch contacts of the relay. The operating power for this relay is provided by a splice connection into the CHM output that also controls the the AMU/AAVA solenoid. Pressing the axle shift switch shifts the axle to high range which causes the CHM to power both the the AMU/AAVA solenoid and the relay.

The energized relay swings the switch contacts open and removes the ground signal from the ECM, thus communicating that the axle is in high range. Nonmultiplexed Controls Suspension Dump The suspension dump is available on a vehicle with rear air suspension. When activated, the suspension dump deflates the suspension air bags to lower the rear of the vehicle. Most vehicles with a suspension dump have an automatic refill that will inflate the rear suspension when the engine is turned off. NOTE: To protect the chassis, the suspension dump is turned off when the vehicle speed reaches approximately 5 mph (8 km/h). The suspension dump is available in two options.

The first option has a lock solenoid that keeps the suspension in the last selected state when the en- gine is turned off. The second option does not have a lock solenoid; when the engine is turned off, the suspension inflates. Suspension Dump Controls On a vehicle with a manual transmission, the axle shift switch that activates the two-speed axle is built into the transmission shift knob. Because of the axle shift switch location, the controls are nonmultiplexed. The switch signals go directly to the AMU/AAVA sole- noid that supplies the airflow to shift the two-speed axle. The axle shift switch operates as a two- position, latching switch with selections for low or high speed ranges.

If the engine is turned off, then restarted, the two-speed axle defaults to low range. With the engine running, the suspension dump can be activated using a momentary, two-position smart switch. Press the upper half of the suspension dump switch to deflate the suspension air bags and lower the rear of the vehicle. Press the upper half of the suspension dump switch again to raise the suspen- sion to its normal height. See Fig. 3 . The rear sus- pension also inflates when: With the engine running, selecting high range with the axle shift switch within the transmission shift knob closes the switch contacts and supplies power to a normally closed AMU/AAVA solenoid.

The ener- gized solenoid opens and supplies compressed air to the gear housing. The air sent to the housing shifts the axle into high gear. Selecting low range with the control switch opens the switch contacts and re- moves the power supply to the AMU/AAVA solenoid, stopping the air supply to the gear housing. With a no-air condition at the housing, the axle shifts into low gear. Vehicle speed reaches approximately 5 mph (8 km/h); The engine is turned off and the autofill feature activates. For nonmultiplexed two-speed axle controls, axle range feedback is supplied to the ECM. An axle switch controls a relay that delivers a ground input to the ECM.

The absence or presence of this ground signal indicates to the ECM what gear range the axle is in. In low range, the axle switch closes and com- pletes a ground path for the relay. Since the relay receives power from a BHM-powered splice pack, the completed ground path through the axle switch allows the relay to energize. In high range, the relay is not energized because the axle shift switch is open and the relay is not grounded. 10/26/2001 f610597 Fig. 3, Suspension Dump Switch When the suspension dump switch is activated, the CHM transmits a low-current output to a normally closed air management unit (AMU) solenoid.

On AAVA vehicles, the solenoid current is about 1.5 Business Class M2 Workshop Manual, Supplement 22, September 2012 050/3