Doors 72.00 Door Removal and Installation CAUTION 9. Install the exterior side cowl panel. Do not attempt to lift the door. The door weighs approximately 110 pounds (50 kg). Lifting or dropping the door could result in personal injury or damage to the door assembly and other com- ponents. 10. Connect the batteries. 11. If applicable, check that the door electrical com- ponents are operating correctly. 9. Using a door support or help from an assistant, support the door frame from its bottom to prevent it from falling or tipping during removal. With the door open and supported, loosen the capscrews that attach the the hinges to the door. Installation 1.
If the door seal has been damaged or is weath- ered, replace it. For instructions, refer to Sub- ject 120 . CAUTION Do not attempt to lift the door. The door weighs approximately 110 pounds (50 kg). Lifting or dropping the door could result in personal injury or damage to the door assembly and other com- ponents. 2. Using a door support or help from an assistant, support the door from its bottom to prevent it from falling or tipping during installation. 3. Install the hinge fasteners. Tighten the cap- screws 11 to 13 lbf·ft (14 to 18 N·m). 4. Close the door and check for alignment. Adjust the door if needed; see Subject 160 . 5. Install the door check assembly as follows.
5.1 Attach the door check to the edge of the door. Tighten the nuts 50 to 70 lbf·in (600 to 800 N·cm). 5.2 Attach the clevis bracket to the cab. Tighten the capscrews 50 to 70 lbf·in (600 to 800 N·cm). 6. If replacing the door, install all components on the door; see the appropriate subjects in this section. 7. Install and connect the door wiring harness. 8. Install the door interior trim panel; see Sub- ject 100 . Business Class M2 Workshop Manual, Supplement 21, March 2012 110/2