Freightliner — Freightliner Business Class M2 Workshop Manual

Doors 72.00 Door Seals Replacement Replacement Lower Seal There are four seals for the cab door (see Fig. 1 ): 1. Apply the parking brake and chock the tires. Primary seal 2. Open the door. Secondary seal 3. Remove the old seal from the bottom of the cab doorway. It is held in place with double-sided tape. Rain gutter seal Primary Seal Lower seal 4. Using alcohol, clean the surface of any old adhe- sive or dirt. 5. Install the new lower seal. Make sure it is com- pletely seated. Apply pressure to the areas of the seal that have adhesive tape to seat the seal firmly. 1. Apply the parking brake and chock the tires. 2. Open the door. 3. Remove the old seal from the door.

It is held in place with double-sided tape and integral retainer clips. 6. Close the door and check the fit. Adjust if neces- sary. Rain Gutter Seal 4. Using alcohol, clean the surface of any old adhe- sive or dirt. 5. Install the new primary seal with the lip toward the edge of the door. Make sure the retainer clips are pushed all the way into their holes, and the seal is flat against the surface all the way around. Apply pressure to the areas of the seal that have adhesive tape to seat the seal firmly. 1. Park the vehicle on a level surface, shut down the engine, set the parking brake, and chock the tires. 2. Open the door. 3. Remove the rain gutter seal from the cab door- way.

It is held in place by double-sided tape. 6. Close the door and check the seal. Adjust if nec- essary. Secondary Seal 4. Using alcohol, clean the surface of any old adhe- sive or dirt. 5. Install the rain gutter seal. Make sure it is pushed all the way on. Apply pressure to the areas of the gutter that have adhesive tape to seat the gutter firmly. 1. Apply the parking brake and chock the tires. 2. Open the door. 3. Remove the tread plate at the bottom of the doorway, then loosen up the upholstery panel. 6. Close the door and check the fit. Adjust if neces- sary. 4. Remove the old seal from the cab doorway. It fits over an edge. 5. Using alcohol, clean the surface of any old adhe- sive or dirt.

6. Install the new secondary seal. Start at the bot- tom and work your way around. Make sure it is pushed all the way on. Apply pressure to the areas of the seal that have adhesive tape to seat the seal firmly. 7. Put the upholstery in place, then install the tread plate. 8. Close the door and check the seal. Adjust if nec- essary. Business Class M2 Workshop Manual, Supplement 21, March 2012 120/1