Cab Heater and Air Conditioner, Valeo 83.00 General Information Suction Side The low pressure area of the system, extending from the expansion valve to the compres- sor inlet. Air Conditioner When the air conditioner is on, the compressor squeezes the refrigerant into a high-pressure, high- temperature gas. High pressure raises the condensa- tion point of refrigerant gas, which allows the con- denser to change it to a liquid. After it is compressed, refrigerant gas passes out of the discharge port of the compressor and on to the condenser. Thermistor A vacuum pressure sensor that is used to measure, in microns of mercury, the internal sys- tem vacuum level after evacuation.
Thermostatic Vacuum Gauge A high-vacuum gauge sensitive to pressures ranging from atmospheric pressure to less than 1 micron of mercury, with scales reading from 25,000 microns to 1 micron of mercury. At the condenser, air passing over the fins absorbs heat from the hot refrigerant gas. As the gas cools, it changes back to a liquid. The liquid moves to the receiver-drier, which filters it and removes traces of moisture and acids. Thermostatic Switch A temperature-sensitive switch used to control system temperature and prevent evaporator freeze-up. It does this by controlling the compressor’s clutch operation.
From the receiver-drier, liquid refrigerant moves to the expansion valve, which meters the flow into the evaporator and acts as a boundary between the high- and low-pressure sides of the system. The me- tered release of the expansion valve greatly drops the pressure of the liquid, causing it to expand. The pressure drop lowers the boiling point of the refriger- ant and causes it to evaporate quickly, as it absorbs heat from air passing over the evaporator. The result- ing cool air is forced into the cab by the blower. The heated refrigerant gas is drawn back into the com- pressor where the cycle is repeated.
Undercharge A system low on refrigerant resulting in lack of cooling and possible compressor damage. Vacuum Refers to pressure that is less than atmos- pheric pressure. Vacuum Pump A mechanical device used to evacu- ate and create a high vacuum in the refrigerant sys- tem. Vacuum Pump Oil Water soluble oil used in some vacuum pumps to absorb moisture from the refriger- ant system. Water Regulating Valve The mechanically or elec- tronically controlled valve, used for controlling the flow of coolant to the heater core. Vapor The gaseous state of a material. Principles of Operation In a blend air system, the heater core is always filled with hot water.
Air enters the HVAC assembly through the blower and blows through the evapora- tor. If the refrigerant compressor is engaged, the air is cooled by moving the heat from it into the evapo- rator, where the refrigerant absorbs the heat and car- ries it away. The temperature blend doors then direct the air through or around the heater core, depending on the climate control settings. The temperature blend doors are used to blend the correct amount of cold and hot air to reach the desired temperature. The temperature blend, air distribution, and recircula- tion levers and doors are controlled by actuators. Business Class M2 Workshop Manual, Supplement 18, September 2010 050/7