Freightliner — Freightliner Business Class M2 Workshop Manual

Cab Heater and Air Conditioner, Valeo 83.00 Heater Core Replacement Replacement rior of the vehicle to prevent any damage from an antifreeze spill. IMPORTANT: Freightliner LLC does not recom- mend the use of any type of coolant system sealer or leak stop product. 10. Wearing protective gloves, remove the heater core and drain any remaining coolant from the heater core. 1. Turn off the engine, apply the brakes, and chock the tires. 11. Remove any debris or coolant that may be in the heater core housing. 2. Disconnect the batteries at the negative termi- nals or at the battery shutoff switch. 12. Wearing protective gloves, install a new heater core in the HVAC assembly. 3.

Remove the air cleaner. For instructions, see Section 09.01 , Subject 110. CAUTION 4. Remove the surge tank. For instructions, see Section 20.01 , Subject 130. Do not overtorque the capscrew. Overtorquing the capscrew may crack the heater core. 5. Remove the Torx ® capscrew that attaches the coolant lines to the heater core. Remove the coolant lines from the heater core. 13. Using a Torx capscrew, attach the coolant lines to the heater core and torque the capscrew 30 lbf·in (340 N·cm). 6. Remove the following dash panels inside the cab. See Fig. 1 . For instructions, see Sec- tion 60.08 . 14. Attach the heater core service cover to the HVAC assembly. 15.

Using capscrews, attach the HVAC wiring har- ness to the heater core service cover, securing both the wiring harness and the cover. lower HVAC cover trim plate panel cup holder panel 16. Using capscrews, attach the actuator to the heater core service cover and the HVAC assem- bly. right-hand dash panel 7. Remove the capscrews that attach the tempera- ture blend actuator to the HVAC assembly and remove the temperature blend actuator. See Fig. 2 . 17. Install the dash panels. For instructions, see Section 60.08 . 8. Remove the capscrews that attach the HVAC wiring harness to the HVAC assembly. 18. Install the surge tank. For instructions, see Sec- tion 20.01 , Subject 130. 19.

Install the air cleaner. For instructions, see Sec- tion 09.01 , Subject 110. 9. If the original heater core is being replaced, use a sharp utility knife to cut within the groove on the heater core access panel. Remove and dis- card the heater core access panel. See Fig. 3 . 20. Connect the batteries at the negative terminals or at the battery shutoff switch. If there is a heater core service cover in front of the heater core, remove the service cover. 21. Remove the chocks from the tires. WARNING Failure to wear protective gloves could result in serious skin cuts due to the sharp edges on the heater core fins. IMPORTANT: A small amount of antifreeze may be present in the heater core.

Protect the inte- Business Class M2 Workshop Manual, Supplement 8, September 2005 110/1