Cab Heater and Air Conditioner, Valeo 83.00 Actuator Replacement Temperature Blend Actuator Replacement 2. Remove the lower HVAC cover. For instructions, see Group 60 . 3. Disconnect the wiring harness from the air distri- bution actuator. See Fig. 1 . 1. Turn off the engine, apply the brakes, and chock the tires. 4. Remove the capscrews that attach the actuator to the mounting plate and remove the actuator. 2. Remove the lower HVAC cover. For instructions, see Group 60 . 5. Before installing a new actuator, rotate the cam behind the mounting plate so that the alignment hole in the cam is aligned with the hole in the HVAC assembly. See Fig. 2 . 3.
Disconnect the wiring harness from the tempera- ture blend actuator. See Fig. 1 . 1 2 A 01/17/2002 f831473 A. Align the hole in the cam with the hole in the HVAC assembly. 1. Cam 2. Mounting Plate 1. Temperature Blend Actuator 2. Air Distribution Actuator 3. Blower Motor 4. Recirculation Actuator IMPORTANT: If the alignment hole in the cam is not aligned with the hole in the HVAC assembly, the actuator could be installed with the cam 180 degrees from the correct position. Incorrect alignment of the cam will prevent the air distri- bution doors from operating correctly. Fig. 2, Cam Alignment for the Air Distribution Actuator Fig. 1, Actuators 4.
Remove the capscrews that attach the actuator to the HVAC assembly and remove the actuator. 5. Using capscrews, install the new actuator on the HVAC assembly. Make sure that the actuator is correctly aligned on the door extension. 6. Using capscrews, install the new actuator on the mounting plate. Make sure that the actuator is correctly aligned on the door extension. 6. Attach the wiring harness to the temperature blend actuator. 7. Attach the wiring harness to the air distribution actuator. 7. Attach the lower HVAC cover to the dash panel. For instructions, see Group 60 . 8. Remove the chocks from the tires. 8. Attach the lower HVAC cover to the dash panel. For instructions, see Group 60 .
Air Distribution Actuator Replacement 9. Remove the chocks from the tires. 1. Turn off the engine, apply the brakes, and chock the tires. Business Class M2 Workshop Manual, Supplement 6, September 2004 150/1 1 12/02/2003 2 3 4 f543877