Cab Heater and Air Conditioner, Valeo 83.00 Heater and Air Conditioner Assembly or Heater Assembly Replacement Replacement 13. Using only Mini Stat-O-Seals, replace the Mini Stat-O-Seals on the refrigerant lines. Do not lu- bricate the Mini Stat-O-Seals prior to installation. 1. Turn off the engine, apply the brakes, and chock the tires. 14. Using a capscrew, attach the refrigerant lines to the expansion valve. Torque the capscrew on the retaining plate 11 to 15 lbf·ft (15 to 20 N·m). 2. Disconnect the batteries. 3. Remove the surge tank. For instructions, see Section 20.01 , Subject 130. 15. Using a Torx capscrew, attach the coolant lines to the heater core. 4. Remove the air cleaner.
For instructions, see Section 09.01 , Subject 110. 16. Install the dash panels. For instructions, see 5. If equipped with an air conditioner, recover the refrigerant from the air conditioning system. For instructions, see Section 83.00 , Subject 220. Section 60.08 . 17. Install the surge tank. For instructions, see Sec- tion 20.01 , Subject 130. 6. Remove the Torx ® capscrew that attaches the coolant lines to the heater core and remove the coolant lines. 18. Install the air cleaner. For instructions, see Sec- tion 09.01 , Subject 110. 19. Connect the batteries. 7. Remove the capscrew that attaches the refriger- ant lines to the expansion valve and remove the refrigerant lines.
Quickly cap the refrigerant lines. 20. Remove the chocks from the tires. IMPORTANT: Under no circumstances should the refrigerant lines remain uncapped for longer than five minutes. Water and dirt can damage the refrigerant system. Do not blow shop air through the refrigerant lines since shop air is wet (humid). 8. Remove the following dash panels inside the cab. See Fig. 1 . For instructions, see Sec- tion 60.08 . lower HVAC cover trim plate panel cup holder panel right-hand dash panel 9. Disconnect the two HVAC wiring harnesses. 10.
Remove the capscrews, nuts, and washers that attach the heater and air conditioner assembly or heater assembly to the dash and frontwall and remove the assembly. 11. Using capscrews, nuts, and washers, attach the new heater and air conditioner assembly or heater assembly to the dash and frontwall. Torque the capscrews 72 to 96 lbf·in (810 to 1080 N·cm). Torque the nuts 18 to 19 lbf·ft (24 to 26 N·m). 12. Connect the two HVAC wiring harnesses. Business Class M2 Workshop Manual, Supplement 6, September 2004 160/1