Cab Heater and Air Conditioner, Valeo 83.00 Expansion Valve Replacement Replacement 8. If the evaporator lines were capped, uncap the lines. 1. Turn off the engine, apply the brakes, and chock the tires. 9. Using only Mini Stat-O-Seals, replace the Mini Stat-O-Seals on the evaporator side of the ex- pansion valve. Do not lubricate the Mini Stat-O- Seals prior to installation. 2. Open the hood. 3. Recover the refrigerant from the air conditioning system. For instructions, see Subject 220 . 10. Using two capscrews, attach the expansion valve to the evaporator lines. Torque the capscrews 35 lbf·in (395 N·cm). 4. Remove the air cleaner. For instructions, see Section 09.01 , Subject 110. 5.
Remove the surge tank. For instructions, see Section 20.01 , Subject 130. 11. Using only Mini Stat-O-Seals, replace the Mini Stat-O-Seals on the refrigerant lines. Do not lu- bricate the Mini Stat-O-Seals prior to installation. 6. Remove the capscrew that attaches the refriger- ant lines to the expansion valve and remove the refrigerant lines. Quickly cap the refrigerant lines. See Fig. 1 . 12. Attach the refrigerant lines to the expansion valve. Torque the capscrew on the retaining plate 11 to 15 lbf·ft (15 to 20 N·m). 13. Install the surge tank. For instructions, see Sec- tion 20.01 , Subject 130. 3 3 4 5 14. Install the air cleaner. For instructions, see Sec- tion 09.01 , Subject 110.
2 15. Evacuate and charge the air conditioning system with refrigerant. For instructions, see Sub- ject 220 of this section. 16. Be sure to add refrigerant oil to the compressor to replace that which is lost when the system is recovered. See Section 83.01 , Subject 130. 3 3 1 17. Return the hood to the operating position. 18. Remove the chocks from the tires. 01/15/2002 f831465 2 1. Refrigerant Line 2. Capscrew 3. Mini Stat-O-Seal 4. Expansion Valve 5. Evaporator Line Fig. 1, Expansion Valve IMPORTANT: Under no circumstances should the refrigerant lines remain uncapped for longer than five minutes. Water and dirt can damage the refrigerant system.
Do not blow shop air through refrigerant lines since shop air is wet (humid). 7. Remove the capscrews that attach the expansion valve to the evaporator lines and remove the ex- pansion valve. If the evaporator lines will be ex- posed to air for more than five minutes, cap the evaporator lines. Business Class M2 Workshop Manual, Supplement 0, January 2002 170/1