Freightliner — Freightliner Business Class M2 Workshop Manual

Cab Heater and Air Conditioner, Valeo 83.00 Troubleshooting Preliminary Checks brackets to the fan and hub 180 degrees apart. It is important to use two brackets to prevent vibra- tion when testing. The brackets can be made by drilling and bending 3/4-inch x 1/8-inch (19-mm x 3-mm) mild steel strap. Before testing the operation of the air conditioning system, check the following items: 1. Make sure the drive belt on the refrigerant com- pressor is not damaged. Make sure the compres- sor mounting capscrews are tight. The cap- screws should be torqued 15 to 19 lbf·ft (20 to 26 N·m). 2 2. Using a feeler gauge, check the refrigerant com- pressor for correct clutch clearance.

See Sec- tion 83.01, Subject 140 for instructions. 3. Check for broken or cut hoses. Check for loose fittings on all parts. 4. Check for road debris buildup on the condenser coil fins. Using air pressure and a whisk broom or a soapy spray of water, carefully clean off the condenser. Be careful not to bend the fins. 1 1 3 5. If there is not enough airflow, make sure that leaves or other debris have not entered the fresh air ports under the windshield. If debris is present, it could clog the air inlet and block air- flow. Remove the debris carefully. 07/28/2006 f831490 1. Z-Shaped Bracket 2. Fan 3. Hub Fig. 1, Viscous Fan Be sure that all ducts are connected to the dash outlets.

WARNING Use two brackets to lock the fan. If two brackets are not used, the bolts could shear or the fan could become unbalanced resulting in personal injury or damage to the fan. Air Conditioning System Performance Test If the system does not operate within the following guidelines, further diagnosis and repair may be nec- essary. 5. Open the driver and passenger doors. 6. Connect the A/C test gauges to the refrigerant system service ports. 1. Park the vehicle out of direct sunlight, shut down the engine, and chock the tires. 7. Place a thermometer in the center dash outlet. 2. Open the hood. NOTE: Make a printed copy of Table 1 to use for recording the readings taken for this proce- dure.

8. Start the engine and warm it to operating tem- perature. 9. Set the engine speed to 1500 rpm. 10. Set the control panel to normal A/C, the recircu- lation to off, and the fan to the highest speed. 3. Record the ambient temperature and the relative humidity in Table 1 . 11. Allow time for the system to stabilize (at least 5 minutes or until the dash outlet temperature is at minimum) then record the values in Table 1 under the "Actual Readings" heading. 4. Make sure the engine fan is engaged. If equipped with a viscous fan, the fan must be manually locked before testing the A/C system. 12. Refer to the appropriate temperature/pressure table in Subject 400 .

Using the recorded ambi- ent temperature and relative humidity readings, locate the values in the temperature/pressure To lock the fan, make two Z-shaped brackets similar to those shown in Fig. 1 . Mount the Business Class M2 Workshop Manual, Supplement 13, March 2008 300/1