Freightliner — Freightliner Business Class M2 Workshop Manual

TwinFlow Fire Pump 90.00 AutoLube Seal Replacement Replacement impeller). Install the bushing from the impeller side of the inner half of the AutoLube. See Fig. 1 . 1. Park the vehicle on a level surface. Shut down the engine. Set the parking brake and chock the front and rear tires. 2 3 2. Drain the water from the pump. 3. Remove the fill and drain plugs from the AutoLube reservoir and drain the oil. 4 5 4. Use a center punch to mark the AutoLube cover and the front bearing housing (for proper align- ment during assembly). 1 CAUTION Do not use a chisel to separate the AutoLube from the pump body because the mating sur- faces may be scratched or gouged, which could result in a leak.

Also, the AutoLube is manufac- tured from cast metal, and if it becomes neces- sary to pry the AutoLube apart from the pump body, pry between the AutoLube and the pump body or at the AutoLube "notches." See Fig.1 . 6 7 8 f190012 07/22/98 1. Cut Water 2. Impeller Shaft Bushing 3. Seal Lockring 4. Oil Seal 5. Front Bearing Housing 6. Water Passage 7. Pry Notch 8. AutoLube Cover 5. Remove the 1/2–13 x 2 capscrews that attach the AutoLube to the pump body, then gently pry the AutoLube from the pump body and impeller shaft. Fig. 1, Impeller Side of the AutoLube 6. Place the AutoLube face down on a workbench, then remove the two 3/8–16 x 3/4 Allen-head capscrews from the impeller side.

Separate the two halves and remove the diaphragm. CAUTION The impeller shaft bushing seats against a shoul- der in the inner half of the AutoLube and can only be removed and installed as described or the AutoLube may be damaged. 7. Remove the seal lockring. 8. Remove the oil seal from the inner half of the AutoLube. 14. Install a new oil seal in the inner half of the AutoLube. 9. Check the impeller shaft bushing for wear. 15. Install the seal lockring. 10. Clean the inner and outer halves of the AutoLube. 16. Position the diaphragm on the inner half of the AutoLube. 11. Clean the gasket surfaces of the AutoLube and the pump body. 17.

Line up the marks, and place the outer half of the AutoLube onto the inner half. Apply Loctite ® 242 to the two 3/8–16 x 3/4 Allen-head cap- screws. Tighten the capscrews 30 lbf·ft (41 N·m). 12. Check for restrictions in the water passages to the rear part of the AutoLube. 13. If it is necessary to replace the impeller shaft bushing, press the bushing from the inner side of the inner half of the AutoLube (side opposite the 18. Install a new gasket on the AutoLube, and posi- tion the assembly (with the top up) onto the im- peller shaft. Attach the AutoLube with 1/2–13 x 2 capscrews and tighten them to 80 lbf·ft (108 N·m). Business Class M2 Workshop Manual, Supplement 9, March 2006 100/1