TwinFlow Fire Pump 90.00 Fire Pump Gearbox Removal, Disassembly, Assembly, and Installation 3.1 Remove the three 5/16–18 x 1 capscrews from the shift cylinder, then carefully slide the shift cylinder from the piston. bearing cones, and spacers, when removed, be kept together in matched sets. Input and output shaft bearing and spacer sets are different. Fail- ure to keep matched sets together or to not use factory pre-set and matched bearing and spacer sets will void the warranty, and may result in gearbox failure. There are two bearings of different widths sup- porting the drive gear on the input shaft.
It is im- portant that these bearings be installed in the drive gear in the proper location. Note the loca- tion of the bearings when removed. Failure to in- stall the bearings properly can result in gearbox failure. 3.2 Remove the nut, then remove the piston from the shift shaft. Remove the seal ring from the piston. CAUTION Do not remove the piston from the shift yoke shaft unless it is damaged (and replacement is mandatory). When installing a new piston, install a new locknut and snugly tighten it, but do not overtighten as the nut can become distorted, which can cause shift failures.
3.8 Reaching through the top of the gearbox housing, carefully remove the drive gear, the inner bearing cone, and thrustwasher. Remove the drive gear bearings. 3.3 Remove the shift shaft, the shift fork, and the shift ring assembly from the gearbox. Make sure the shift ring does not get dropped or damaged. 3.4 Note the location and orientation of the shift fork on the shaft, then remove the 3/8–16 x 1-1/4 screw from the shift fork, and remove the fork from the shift shaft. 3.9 Using a magnet, remove the positioning pins from the windage tray. Remove the windage tray and the positioning springs. 3.10 Remove the input shaft seal. 3.11 Remove the outer bearing cone.
3.5 Remove the shift shaft support block. Then remove the seal from the support block. 3.12 Using a brass drift, carefully drive out the outer bearing cup from the inside out. Re- move the internal retaining ring and the spacer(s). NOTE: One ear of the shift yoke is ma- chined and will fit one way. Make a note of the location of the machined ear when re- moving the shift yoke. 3.13 Using a brass drift, carefully drive out the inner bearing cup from the outside in. 4. Inspect the cooling tube for damage and leaks. 3.6 Remove the 3/4–10 x 1-1/2 capscrew that attaches the front driveline yoke to the input shaft. Remove the yoke. 5.
Remove the gearbox oil filter from the suction inlet on the gearbox housing. 3.7 Remove the input shaft by sliding the in- put shaft from the output shaft housing opening at the rear of the gearbox. Use caution when sliding the input shaft through the bearing cones, the thrust- washer, and the drive gear. Place wooden blocks to support the drive gear and to protect the windage tray, and force the shaft loose. 6. Clean and inspect each component of the gear- box assembly. Inspect the bearing cups and the cones for wear, pitting, and damage. Inspect the gear tooth surfaces for wear, damage, and pit- ting. Inspect the shift shaft block for wear.
In- spect the gasket surfaces for nicks and gouges. Replace all components that are worn, damaged, or pitted. Assembly CAUTION Bearing cups, cones, and spacers are factory pre-set for end play, and are only provided as a matched set. It is important that bearing cups, 1. Install a new gearbox oil filter. 2. Assemble and install the input shaft assembly. Business Class M2 Workshop Manual, Supplement 8, September 2005 110/5