Freightliner — Freightliner Business Class M2 Workshop Manual

PowerFlow Fire Pump 90.01 Fire Pump Gearbox Removal, Disassembly, Assembly, and Installation 4 5 6 7 6 box use O-ring type seals (not gaskets) that can be easily damaged. Petroleum jelly can be used as a lubricant to ease the assembly process. Gasket cements or glues are not required. 1. Install the intermediate shaft. Place the interme- diate gear in position. Install the key in the inter- mediate shaft and slide the intermediate shaft through the gear from the front of the gearbox. Install the spacer. Install the front bearing cover and tighten the bolts to 28 lbf·ft (38 N·m). Install the rear bearing cover and tighten the bolts. Check the intermediate shaft assembly for ease of rotation.

3 8 1 2 07/12/2001 f190031 1. Nut 2. Cotter Pin 3. Impeller Shaft 4. Slinger 5. Bearing 6. Spacer 7. Impeller Shaft Gear 8. Key 2. Install the main drive gear through the opening in the side of the gearbox. Install the drive gear bearings on the input shaft and slide the input shaft through the main drive gear from the rear to the front. Attach the bearing retainer and shift gear to the main drive gear and tighten the bolts. Slide the spacer on the input shaft from the front of the gearbox. Fig. 8, Impeller Shaft and Related Components 3 3. Install the front bearing retainer and tighten the bolts to 28 lbf·ft (38 N·m). 4.

Install the input shaft yoke and tighten the new locknut 200 lbf·ft (271 N·m). 1 2 5. Install shift shaft O-ring into case. 08/09/2001 f190032 3 6. Install the shift rod, shift fork, and sliding shift gear from the rear of the gearbox. See Fig. 11 . 1. Bearing 2. Intermediate Shaft End Cap 3. Jack Bolt Holes 7. Install the retaining rings. Install the shift indica- tor switches. Fig. 9, Intermediate Shaft Bearing Cover NOTE: The output housing Allen-head attaching bolts are two different lengths. Be sure to install the short bolt in the correct location. the intermediate gear from the front to the rear. See Fig. 10 . NOTE:

The intermediate gear is a tight pressed fit and is keyed to the shaft. 8. Install the output housing assembly. Slide the output housing assembly over the input shaft, being careful not to damage the pilot bearing. Install the attaching bolts and tighten them to 28 lbf·ft (38 N·m). 20. Press the front bearing off of the impeller shaft towards the seal area. 21. Clean all components, seal areas, and gasket surfaces. Check for wear or damage. 9. Install the air shift cylinder and tighten the bolts to 10 lbf·ft (13 N·m). 10. Install the rear bearing cover and bearing for the impeller shaft. Tighten the bolts to 28 lbf·ft (38 N·m). Assembly NOTE:

When rebuilding the gearbox, replace all seals, bearings, and gaskets. Care must be taken, as most of the components of the gear- 11. Install the impeller shaft assembly from the front to the rear. Business Class M2 Workshop Manual, Supplement 8, September 2005 100/5