daewoo Solar 420LC-V, Solar 470LC-V — Daewoo S0101000.FM — user manual

CLEANING AND INSPECTION (WEAR LIMITS AND TOLERANCES) Inspect all components and precision surfaces, to confirm that they haven’t been worn beyond service limits. Refer to table below for dimensional specifications. All parts should be cleaned, air-dried and re-lubricated with clean, approved-type hydraulic fluid, before final reassembly or as the final step after the unit has been put back together. Replacement of all O-rings and oil seals with new parts is generally recommended, unless motor has had minimal use. Inspect O-rings and oil seals very carefully for cuts, nicks, brittleness or softness, or any other type of damage or distortion, before final reassembly. NOTE:

When parts exceed the standard, replace them. When there is conspicuous surface damage, it is always safer to replace parts, whether standards are exceeded or not. 1 2 D L 3 4 5 a t HBOA230L Figure 25 NOTE: Spherical bushing and push plate must always be replaced as a set. If either one requires replacement, replace the other 1. Clearance Between Piston and Cylinder Bore (D-d) 2. Spring Free Length (L) 3. Thickness of Shoe (t) 4. Piston Ball - Shoe Socket Clearance (a) 5. Height Between Round Bushing and Push Plate (H-h) S0707260 Page 19 Swing Motor d H h