3. Reassemble drive shaft (101, Figure 4), roller bearing (443) and lower casing (301). Pay attention to bearing alignment inside bore of case. Make sure it is fully seated. Figure 29 4. There is a "right side" and "wrong side" on oil seal. Be careful that you install seal inside cover with correct side facing in. Figure 30 5. Before replacing O-ring (471) in lower casing (301), grease O-ring (and/or inside of groove) very lightly, to facilitate assembly and to help protect O-ring from accidental damage. Figure 31 6. Put a little grease on lip of front cover oil seal before replacing front cover and tapping it lightly into place with plastic hammer. Figure 32 S0707260 Page 22 Swing Motor