daewoo Solar 420LC-V, Solar 470LC-V — Daewoo S0101000.FM — user manual

REASSEMBLY Reassembly of the motor is basically accomplished by reversing disassembly steps. Use a torque wrench to make sure that assembly fasteners are tightened to specified values. Always begin a bolt tightening sequence from the innermost part of the assembly, working outward toward the ends in careful, even rotation. 1. Position motor casing face down (Figure 26). Figure 26 2. If drive shaft roller bearings were not disassembled, go onto next phase of assembly. Bearing reassembly begins with replacement of stop ring (432) (Figure 4 and its accompanying Parts List) and spacer (106) on drive shaft (101). Figure 27 Make sure that bearing raceways (collars) are facing right direction.

The drawing shows one side of the bearing collar (1, Figure 28), marked "R," which should be assembled next to spacer (2) on lower end of drive shaft. A. Both bearing cages (inner roller assemblies) will probably require heating in oil before reassembly. Heat bearings to cause sufficient expansion of their inner diameters to allow reassembly on drive shaft. Figure 28 S0707260 Page 21 Swing Motor