11. Put cylinder block (111) and retainer plate (123) back in motor. Spherical bushing and grooves of cylinder block splines should fit together without undue difficulty. (Do not try to force or pound parts together.) Figure 37 12. Turn motor so that front cover side (304) is down. Put separator plates (743) and friction plates (742) back in same order in which they were removed. There are three separator plates (743) and two friction plates (742), which should be positioned as shown in drawing below, with clearance towards side of casing with brake valve (1, Figure 38). Figure 38 \ 13. Very lightly grease larger O-rings (706 and 707, Figure 4) before replacing them in casing (301).
Figure 39 14. Position brake piston (1, Figure 40) in casing. The diagram shows position of four piston grooves (2) in relation to valve- connected side (3), and two 8 mm bolts which should be tightened in an even, progressive rotation. Figure 40 S0707260 Page 24 Swing Motor Reference Number Description 1 Brake Valve Reference Number Description 1 Brake Piston 2 Groove 3 Valve-connected Side