SERDIA ERROR MEMORY 5.1.1 ERROR MEMORY (EMR) List of possible error locations of the EMR: - 8002: (F18)Signal monitoring PWM-lnp1 - 8012: F21)Signal monitoring PWM-lnp2 - 8020: ECU (positioner actuation) - 8030: shutoff magnet - 8112: (M17) Rack travel sensor - 8120: (F24) AccelerPedal(SWG1) = SWG 1 - 8130: (F20) HandThrottle(SWG2) = SWG 2 - 8140: (M9) CoolantTempSensor - 8150:(M24) BoostPressureSensor - 8160:(M21) OilPressureSensor - 8170:(M13)Speed 1, camshaft - 8180:(M11)Speed 2, terminal W - 8190:(interno)ElectronicsTemperature - 81A0:(M11)Engine speed sensor - 8210:Data loss EEPROM - 8220:Data loss coil data - 8230:
EDCcalibration error - 8305:Speed monitoring - 8343:Coolant temp, monitoring - 8345:Eng.OFF->CoolantTempMonit - 8363:Oil pressure monitoring - 8365:Eng.OFF->OilPressMonit - 8405:Actuator (positioner, travel meter, fuel rack) - 8500:ISO-Bus-Error - 8600:CAN-Bus-Error The possible types of error are: (0) Broken cable or short-circuit (1) Broken cable or short-circuit (2) Measuring point defective (3) Power reduced (4) Limit exceeded, power reduction activated (5) Shutoff limit exceeded/ fallen below The following table may be used as tool for eliminating possible causes of errors occurred. The status of the error pilot light is to be observed: Permanent light:
Error status during which limited engine operation is still possible. The defect must be eliminated as soon as possible to prevent further damage. Error statuses which result in engine shutdown or prevent engine start. The defect must be eliminated to allow restarting of the engine 20-35