SERDIA FUNCTION TEST 6. FUNCTION TEST 6.1 GENERAL This menu item is only activated for users of access level III. The actuator should only be operated with the engine switched off. Figure: Menu for function test of EMR actuator STRUCTURE OF THE DISPLAY WINDOW Measured values are displayed in the top window. You use the "Meas. values" switch to select those measured values you wish to display from all the measured values available (see Chapter 3 Measured values). In the bottom table, the setpoint values and actual values of the actuators are entered. You can only make entries in this table if the ECU has been switched to test mode. You switch to test mode by activating the field "Test mode".
You deactivate this field in order to switch off test mode. You can specify values in the "Setpoint value" in test mode. The actual values are read consecutively and are displayed in the right-hand column. 20-39