SERDIA WHAT SHOULD YOU DO IF...? 8 WHAT SHOULD YOU DO IF ...? 8.1 SERDIA IN GENERAL 8.1.1 ERROR IN ESTABLISHING THE COMMUNICATION LINK If you are unable to establish a communication link despite having an interface and an ECU connected, you will receive the following error message: POSSIBLE CAUSES OF THE ERROR MESSAGE: There is no power supply to the EMR or to the interface. The power supply was interrupted when the engine was shut down. The wrong serial interface has been assigned on the PC (see 8.1.2). There is an incorrect polarity of the power supply from the engine to the interface. You have not connected all 4 leads (+, -, k, I). Incorrect or faulty ECU.
TROUBLESHOOTING, QUICK CHECK FEATURES: The yellow interface LED should light up when you call SERDIA. Measure the power supply diagnostics plug (the interface requires 8-28V DC). Check the serial interface assignment under Windows, usually COM1. Connect a different ECU. ADDITIONAL INFORMATION ON OPERATING VOLTAGE FOR ECUS. INTERFACE AND PC: The EMR ECU is suitable for an operating voltage of a minimum of 10 V to a maximum of 30 V (type12-24V). Current consumption:
5A at 12V 7A at 24V The MVS is only suitable for a operating voltage of 24 V The interface is fed with power from the engine side and is suited for voltages between 12 V and 24 V The ECUs and the interface are protected against incorrect polarity and surge voltage. Nevertheless, connection by mistake (e.g. to 230 V) can result in damage. An optoelectronic coupler integrated in the interface allows you to connect the PC (notebook and printer) to the vehicle battery or the earth without any risk of damage to the ECU and the interface, and without any loss of data. 20-42