SERDIA WHAT SHOULD YOU DO IF...? 8.1.2 INTERFACE CONFIGURATION WITH ISETUP On PCs the COM1 interface may be occupied by the mouse. In this case, you should connect the interface to the second serial interface (COM2). You can then configure this port using SETUP in order to communicate with the interface. PROCEED AS FOLLOWS: Call program SETUP.EXE. Select the other COM port and confirm with OK.. Initialization file ISODRV.INI is updated automatically. Re-start Windows. On many PCs the second serial interface is 25 pole. If this is the case, you should use a hardware adapter (con- version from 25 to 9 poles) when connecting the 9 pole diagnostics interface. ATTENTION! Figure:
Help file screen from SETUP.EXE 8.1.3 ACCESS CONFLICTS UNDER WINDOWS 3.1 The interface driver ISODRV.386 can only be loaded statically. You enter the driver ISODRV.386 in Windows file SYS- TEM.INI under section [386Enh] (at the same time specifying your current directory). This can result in problems with other application programs occurring that also access the serial interface. REMEDY: Call program ISETUP.EXE. Delete driver entry from SYSTEM.INI. Re-start Windows 3.1. 20-43