SERDIA WHAT SHOULD YOU DO IF...? 8.2.5 ENGINE DOES NOT START 20-51 Indication Possible cause Remedy Starter speed > 160 1/min is not rea- ched. Check using multimeter: terminal voltage at star- ter • Replace battery. • Clean earth wire connections. Starter speed ok, fuel rack travels to start position. Faulty fuel supply. • Restore fuel supply. Starter speed ok, fuel rack stays at zero position. No power supply, connected to wrong pins or in- correct polarity. Shutoff solenoid defective or not connected. Fuel rack stiff. Speed sensor defective Starting fuel charge limitation is set too low or co- olant temperature is too high for the EMR.
• Remove vehicle plug and check for correct con- nections pin 14F = + Ubatt pin 1F = -Ubatt pin 2F = -Ubatt •Locate site causing stiffness and remedy as ap- propriate. •Replace sensor, check plug connection and line. Using SERDIA check measured value "(M9)co- olant temperature" in the menu "current measu- red values". Flashing pilot light. There is a serious fault in the EMR system. You should remedy the fault before attempting any further starts. • Locate error using SERDIA. SERDIA error message: "8405: Actuator (positioner, travel meter, fuel rack)".
Identification of fuel rack travel deviation, measu- red value in shutdown range • Replace actuator, see service example, actuator replacement. Additional setting is not neces- sary. SERDIA error message “8170: (M13) Speed 1, camshaft". Short circuit or interruption on the speed sensor (camshaft sensor) or supply line or plug connec- tion. • Replace sensor, check plug connection for con- tamination or corrosion, check lines between vehicle plug and sensor for damage. SERDIA error message: "8210: Data loss EEPROM" "8220: Data loss coil data" "8020: ECU (positioner actuation)" Memory error in the EMR Memory error in the EMR ECU Failure • Replace ECU.
Transfer data from old ECU to the new one (1:1) SERDIA error message: "8160: (M21) OilPressure-Sensor" Oil pressure measured value (M21) lies outside permitted range, also with engine switched off. • Replace sensor, check plug connection for con- tamination or corrosion, check lines between vehicle plug and sensor for damage. SERDIA error message: "8140: (M9) CoolantTemp-Sensor" Coolant temperature measured value (M9) lies ou- tside the permitted range, also with engine switched off. • Replace sensor, plug and line control. SERDIA error message: "8120: (F24) Acceler Pedal(SWGI)" Accelerator pedal sensor incorrectly calibrated.
•Check calibration values in the menu "Calibra- tion" and change if necessary.