Deutz — 8.2 EMR

SERDIA WHAT SHOULD YOU DO IF...? 8.2.8 REPLACING THE EMR ECU The ECU can be replaced in two ways: 1. If the old ECU is damaged but data can still be read (communication with SERDIA is still possible). 1 st step: Copy the engine data record from the old ECU: Switch on ignition/power supply. Call the program SERDIA. In SERDIA, change over to the menu "Parameters"->"Overall programming". Click on the button "ECU -> file". This will read the configuration files. Next, the window "Save as" is opened. Save the file under a name.Save the file under a name. The engine number will be suggested as file name for storage on from SERDIA 2.5.

This suggestion is not compulsive; other file names may be chosen nevertheless. Then confirm with OK. The file (i.e. the engine data record) is then saved under the name . hex. When the data record is transferred from the old ECU, it is then assigned information re- garding the number of hours of engine operation and the number of engine starts. •• End the program. Switch off ignition/power supply. 2nd step: Replace ECU: You must check the compatibility of the ECUs by referring to the following table (same part number). You should also check and ensure the compatibility of the ECU with the actuator. 20-54