Deutz — RENEWAL AND TENSIONING

ALTERNATOR DRIVEBELT 7 - Remove the bolts (11) and detach the fan (12) from the drive pulley; insert the fan in the fan housing (13) and remove the fan and compressor drivebelt (6). 13 11 6 12 F0017320 8 - Loosen the bolts (14), (15) securing the fuel pump, slip off the alternator drivebelt (16) and remove it by pass- ing it between the crankshaft pulley and the front car- rier. 15 16 17 14 F0017330 9 - Fit the new alternator drivebelt (16) in the same way and tension it using a” T ” drive bar and a 3/4” exten- sion, or using a 3/4” angle drive bar through the hole in the fuel pump bracket (18). 15 16 10 - To tension the drivebelt, turn the bar clockwise and tighten the bolts (14) and (15).

14 18 F0017340 11 - The tension is to be checked using the tool and pro- cedure indicated in the engine manual. Static deflection ” A ” on first fitting: 13 mm belt: 450 ± 50 N Static deflection ” A ” after 15 minutes: 13 mm belt: 300 ± 50 N The check should be carried out with the engine cold. A F0017350 30-17