Deutz — REFITTING

4WD PROPELLER SHAFT 11 - Position a jack “ C ” under the shaft (13) and remove the flange bolts and nuts (14). In order to remove the upper bolts, lower the jack positioned in step 3. 1 14 13 F0044641 12 - Separate the flanges, lower the jack “ C “and withdraw the shaft (13) towards the front of the tractor. 2 13 C F0044651 REFITTING THE 4WD PROPELLER SHAFT Refitting is the reverse of removal. 1 Nuts: 43.5 ± 10% Nm (32 ± 10% lb.ft.) Tighten the nuts in a cross-wise sequence. 2 Rear coupling: Grease 1 - Start the engine and engage the front suspension by pressing the relative button in the cab. 2 - Wait a few seconds and then disengage the front sus- pension.

3 - Repeat this operation a number of times to purge the air from the system. 4 - Stop the engine, check the oil level and top up if nec- essary. 30-67