Deutz — REMOVAL

FRONT SUSPENSION CYLINDERS REMOVAL OF THE FRONT SUSPENSION CYLINDERS (Where fitted) All operations must be carried out with the parking brakes applied. 1 - Operate the button in the cab to activate the front sus- pension, fully extending the suspension cylinders. 1 2 - Position and tighten a jack “ A ” under the front carrier (1). A F0044880 3 - Deactivate the suspension so that the cylinders are fully retracted. 4 - Support the swinging support (2) on a stand “ B ” that can be lowered through10-12 cm (4- 5 in.) and switch off the engine. 5 - Remove the front wheels. (For details, see «REMOVAL OF THE FRONT WHEELS»).

2 B F0044670 Discharge residual pressure from the suspension sys- tem by unscrewing the front and rear valves (3) ap- proximately two full turns. Wait a few minutes after discharging the pres- sure, then re-close the valve. 6 - Remove the reinforcing side members. (For details, see «REMOVAL OF THE REINFORCING SIDE MEMBERS»). 3 F0044890 7 - Disconnect the pipes (5), (6) from the left cylinder (4). First loosen the fittings by a few turns, then, be- fore disconnecting the pipes, push them to de- tach them from the couplers and release any residual pressure. Plug the ends of the pipes to prevent the entry of contaminants. 5 4 8 - Unplug the steering sensor connector (7) 6 7 F0044900 30-102