CLUTCH PEDAL AND RELATED DEVICES CLUTCH PEDAL AND RELATED DEVICES 1. Removal of the potentiometer 1 - Remove the centre console and console shroud. (For details, see «REMOVAL OF THE CENTRE CON- SOLE AND SHROUD»). 2 2 - Disconnect the tie-rod (2) from the clutch pedal (1). 1 F0019340 3 - Unplug the connector (4) from the potentiometer (3). 4 - Remove the screws (5) and remove the potentiometer complete with the tie-rod. 5 3 4 F0019350 If a new potentiometer is to be fitted, disconnect the tie-rod (2), remove the cotter pin (6) and the lever (7). Renew the cotter pin at each re-assembly. 3 2 7 6 F0021520 1.1. Refitting the potentiometer. Refitting is the reverse of removal.
After refitting the potentiometer, check the position of the pedal and its travel; check also the calibration val- ues using the programming/diagnostics tester. NOTE After adjusting the height of the clutch pedal, check using the EDS program in section 20 that the output voltage of the potentiometer is 4.3V. If necessary, adjust the length of the tie- rod (2) to obtain this value. 30-161