Deutz — ADJUSTMENT

PARKING BRAKES ADJUSTMENT OF THE PARKING BRAKES 1 - Before proceeding with the adjustment, operate the handbrake lever (1) repeatedly in order to eliminate any play and check that the control cable slides freely. 2 -Apply a dynamometer with a scale of up to 500 Nm to the handgrip, and raise the handbrake lever to the first notch; check that the force applied to reach the first notch is within the normal limits. Normal force: 300 30 N (55 5 lb.) 0 + 0 + 1 F0021660 3 - If the force is outside these limits, screw out the nut (2) with the least clearance and screw in the nut (3) with most clearance.

MAX 1,5 mm MIN 0,5 mm 2 4 - Then check that the distances between the nuts (2) and (3) of the tie-rods (4) are 0.5–1.5 mm (0.02 -- 0.06 in.). 3 4 F0021671 5 - Take the tractor to straight section of apshalted road at least 50 m (97 yard) in length. 6 - Engage gear and move off. 7 - With the tractor in motion, depress the clutch pedal and fully apply the handbrake (1); check that the rear wheels lock up simultaneously. 8 - If the rear wheels do not lock up at the same time, screw in gradually and by just a few degrees the nut (2) corresponding to the wheel that fails to lock up and screw out the nut corresponding to the other wheel .

9 - Repeat the previous operations until both rear wheels lock up simultaneously when the handbrake is fully applied. 10 - Check that parking lever travel is within the normal lim- its. Lever travel: max. 5 notches If adjustment is required, turn the two nuts (2) by equal amounts. 30-183