Deutz — 1.3 GENERAL RULES

INTRODUCTION COMPONENT AND SYMBOL DEFINITIONS - GENERAL RULES 1.2 DEFINITION OF COMPONENTS AND SYMBOLS To prevent any misunderstanding or ambiguity, listed below are definitions for some of the key terms used in this unit. Chapter “3.2 Description of components” shows the wiring diagrams for certain switches and buttons. The following symbols are used for ease of identification: 1.3 GENERAL RULES The inspection, maintenance, troubleshooting and repair operations are essential to ensure that the tractor continues to operate correctly over time and to prevent malfunctions and breakdowns. The scope of this paragraph is to describe repair procedures and to help improve the quality of repairs.

1.3.1 MODIFICATION OF THE TRACTOR'S ELECTRICAL/ELECTRONIC CIRCUITS The manufacturer prohibits any modification or alteration of the electrical wiring for the connection of any non-approved electrical applicances or components. In particular, if it is discovered that the electrical system or a component has been modified without authorisation, the manufacturer will accept no liability for any damage to the vehicle and the vehicle warranty will be invalidated. 1.3.2 MAIN WIRING FAULTS a.

Poor contact between connectors The main causes of poor contact between connectors are incorrect insertion of the male into the female connector, deformation of one or both connectors, and corrosion or oxidisation of the pin contact surfaces. b. Defective pin welding or crimping The pins of the male and female connectors make good contact in the crimped or welded area, but the wires are subjected to excessive tension, leading to breakage of the insulation or the wire itself and a poor connection. 40-4 TERM DESCRIPTION Connector Element used to connect two components (e.g. wiring-switch.

wiring- wiring) Temperature sensor Electrical component that converts the temperature of a medium (air, water, oil, etc.) into a voltage or resistance Pressure sensor Electrical component that converts the pressure of a medium (air, water, etc.) into a voltage or resistance Position sensor Electrical component that converts the angular or linear position of an object into a voltage Pressure switch Switch that changes state (opens or closes a contact) according to the operating pressure in the circuit in which it is installed Thermostat Switch that changes state (opens or closes a contact) according to the temperature of the medium in which it is immersed.

Switch Mechanical component that opens or closes one or more electrical contacts. Solenoid valve Valve operated by applying electrical current to a coil (or solenoid) SYMBOL DESCRIPTION Contact between CLOSED pins (stable position of switch) Contact between CLOSED pins (non-stable position of switch) Indicator LED Indicator lamp