INTRODUCTION GENERAL PROCEDURES c. Disconnecting wiring If components are disconnected by pulling on the wires, or if components are removed with the wires still connected, or if the wiring is subject to a heavy impact this could damage the connections at the pins, breaking strands of wire. d. Penetration of water in connectors The connectors are designed to prevent penetration of liquids (water, oil etc.); however, it is possible that when the tractor is cleaned using high-pressure water or steam, water could penetrate or condense in the connectors.
As the connectors are designed to prevent liquid penetration, any water that does get in will not be able to drain out, and thus may cause shortcircuits across the pins. For this reason it is good practice to dry the connectors with a low pressure jet of compressed air after washing the tractor. e. Oil or dirt on connectors Oil or grease on the connectors or pins can create a poor contact (oil and grease are non- conductors) . Clean the connectors thoroughly using a dry cloth or a low pressure jet of compressed air and use specific products (deoxidising sprays, etc.) to degrease the contacts. Take care not to bend the pins when cleaning them. Use dehydrated not lubricated compressed air.
1.3.3 REMOVAL, REFITTING AND DRYING OF CONNECTORS AND WIRING a. Disconnection of connectors When disconnecting wiring, pull on the connectors rather than on the wires themselves. For connectors that are held in position with screws or levers, fully loosen the screws, then pull on the connector. For connectors that are clipped togther, fully depress the clip then pull the connector apart. After disconnecting connectors, cover them in a waterproof material to prevent dirt or moisture getting into the contacts. b. Connecting the connectors Check the condition of the connectors: Make sure the pin contact surfaces are free of water, dirt or oil.
Check that the connectors are not deformed and that the pins are not corroded. Check that the connector casings are not damaged or split. If a connector is contaminated with oil or grease, or if moisture has penetrated the casing, clean it as described in paragraph 1.3.2. If a connector is damaged, deformed or broken, replace it with a new one. When connecting connectors, make sure they are properly aligned before applying any force. For connectors with clips, insert the two halves until they clip together. c. Cleaning and drying wiring When wiring is dirty or contaminated with oil or grease, clean it with a dry cloth, or, if necessary, with water or steam.
If the wiring has to be cleaned with water, avoid directing the water or steam jet on the connectorsi; if water penetrates the connector, proceed as described in paragraph 1.3.2. Check that the connector is not short circuited by water by testing the continuity across the pins. After checking the connector is in good condition, degrease the contacts using a deoxidising product. 40-5