INTRODUCTION DIAGNOSTIC INSTRUMENTS - WIRE COLOUR CODES d. Renewal of damaged electrical components. When replacing electrical components (fuses, relays, etc.), use only original parts supplied by the manufacturer. When replacing fuses, check that the new fuse conforms to DIN 72581 or ISO 8820 standards and in particular: - fuse F1 (100A) DIN 72581/2 - bayonet fuse (F2, F3, etc.) DIN 72581/3C - fuse F51 (100A) ISO 8820 The fitting of replacement fuses that do not comply with these standards will invalidate the warranty with immediate effect and release the manufacturer from any liability.
When replacing relays, make sure that the new relay conforms to the standards marked on the original relay. 1.4 DIAGNOSTIC INSTRUMENTS For the correct diagnosis of any faults in tne tractor's electrical system, the following instruments are required: 1 - Digital multimeter with the following minimum characteristics: AC VOLT 0-600 DC VOLT..... 0-600 OHM............ 0-32M AC AMP ...... 0-10 DC AMP ...... 0-10 2 - Computer loaded with the “ SERDIA 3 - All Round Tester 1.5 WIRE COLOUR CODES 40-6 COLOUR CODES A Light blue B White C Orange G Yellow H Grey L Dark blue COLOUR CODES M Brown N Black R Red S Pink V Green Z Purple