Deutz — 4.1 CONFIGURATION

SERDIA PARAMETERS 20-26 MK 3 TTG Parameter Unit Min. Max. typ Wert Description Page 14: Start behaviour and cold start aid Starting fuel quantity mm3/ str. 0 200 110 Fuel quantity at start up to idling eng. speed. Applies to coolant temperature > 0°C Fuel quantity high idle mm3/ corsa 0 200 10 Fuel quantity at high idle Suction fuel quantity mm3/ str. 0 200 90 Initial injection quantity w. boost pressure simulation Overfueling 0 20 0 Overfueling recovery 0 25 0 Cold start fuel qty times s 0 600 30 Cold start overfueling time Cold start overfueling mm3/ str. 0 50 20,01 Engine start overfueling for T Eng.speed ramp cold start 1/min/s 5 250 100 Max. eng. speed ramp cold start Max.

PreHeatTime s 0 600 10 Min. PreHeatTime s 0 600 0 ColdSt:PreHeatBackupTime s 0 600 2 Max. PostHeatTime s 0 600 10 Min. PostHeatTime s 0 600 0 const. speed droop °C -30 130 0 CoStMaxHeat Temp(pre&post) °C -30 130 -30 Page 16: Breakaway characteristics const. speed droop 1 % 0 80 6 Speed droop 1 const. speed droop 2 % 0 80 0 Speed droop 2 Engine speed position values 1/min 600...20000 8 engine speed values Variable droop = fct(engine speed) % Speed droop=fct(engine speed) Page 17: Speed-dependent PID control Engine speed position values 1/min 600...2500 7 Engine speed values Quantity position values mm3/ Hub 0...100 4 fuel injection quantity values (ref. points) Speed governor:

P map % 100...200 P-Part=fct(eng.speed, fuel quantity) (28 values) RSpeed governor: I map % 50...100 I-Part=fct(eng.speed, fuel quantity) (28 values) Speed governor: D map % 25...400 D-Part=fct(eng.speed, fuel quantity) (28 values) Page 18: Smoke limitation Boost pressure position values bar 4,0 4 Boost pressure values Engine speed position values 1/min 800...2000 5 Engine speed values fuel injection quantity limit. mm3/ corsa 68...104 Fuel injection quantity=fct(eng.speed,boost pressure) (20 values) Page 19: Simulation of boost pressure sensor after failure Eng. speed pos. values for boost pr. simul 1/mm 800...2500 8 Speed values fuel inj. qty limiting for boost pr. simul. mm3/ str.

20 Fuel inj. quantiy limitation =fct(eng.speed, time) Page 20: Power parameters Max. torque (fix) Nm 0 64255 500