Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS,FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS WARNING 1. Open engine hood (1). 4 - 61 If compressed air, high-pressure wat er, or steam hits your body directly or dirt is s ent flying by the com pressed air, high-pressure water, or steam, there is danger of p ersonal injury. Always wear protective glasses, dust mask, and o ther protective equipment. NOTICE When using compressed air for clean ing, blow it keeping some distance to avoid d amaging the fins. Da mage on the fins ca n cause water leakage and overheating.

In a dusty job site, check the fins ever y day, regardless of the mainte nance interval. 2. 3. Loosen screw (4) and pull u After pulling up net (2) and ( p net (2) and (3). 3), clean it. (Install it again in Step 7.) 4. Check the front and rear surf aces of oil cooler fins (5), radiator fins (6), aftercooler fins (7), Air conditioner condenser fins (8), and fuel cooler fins (9). If the to the fins, blow the dirt off w Steam or water may be u re is any mud, dirt, or leaves stuck ith compressed air. sed instead of compressed air.

However, when carrying (high-pressure machine w out powerful steam cleaning ash) of the heat exchange oler, aftercooler, fuel cooler, air equipment (radiator, oil co conditioner condenser), mai air ntain sufficient distance from the the operation. If steam cleaning sh) is carried out at close range, ernal fins of the heat exchange the machine when carrying out (high-pressure machine wa there is danger that the int equipment may be deformed , and this will cause early clogging and breakage. 5. Check the rubber hose. Rep lace with a new one if the hos e is found to have cracks or to b e hardened by aging. In addition, check the hose clamps for lo oseness.