. MAINTENANCE MAINTENANCE PROCEDURE WARNING circuit. Even go down The pressure in the hydraulic circuit can be released. CHECKING FUNCTION OF ACCUMULATOR (arm fully the work 4 - 73 CHECKING CHARGE PRESSURE OF NITROGEN GAS IN ACCUMULATOR (FOR CONTROL CIRCUIT) The ac cumulator is charged wit h high-pressure nitrogen gas, so mistaken operation may cause an ex plosion, which will le ad to seriou s injury or damage. Whe n handling the accumulator, alw ays do as fo llows. The pressure in the hydrauli c circuit cannot be completely removed. W hen removing the hydraulic equipment, do not s tand in t the he direction that the oil s purts out when carrying out the operation.
I n addition , loosen the bolts slowly when c arryin g out operation. umulator. dispose of it in fire. eld it. t it to any impact. Do not disassemble the acc Do not bring it near flame or Do not make holes in it or w Do not hit it, roll it, or subjec Wh en disposing of the accu mulator, the gas must be rele ased. Please contact y our Komatsu dist ributor to have this work car ried out. FUNCTION OF ACCUMUL The a ccumulator stores the after t he engine is stopped, the control circuit can be op the fo llowing actions are po If t eq un he control lever is ope uipment, it is possible der its own weight. The a ccumulator is installed to the position shown in th on th e right.
Repla ce the accumulator ev ery 2 years or every 4000 h ours, whichever Chec k the nitrogen gas cha 1. S 2. S e e 1. S top the machine on fir 2. S et the work equipme xtended and bucket quipment at a position 1.5 m (4 ft 11 in) above the NOTIC E out the following procedure to lower the work equipment to the ground within 15 seconds of stopping the engine. Carry out the following proced ure to lower the work equipmen t to the grou nd within 15 seconds of sto When the engine stops, the pre ssure in the accumulator gradu ally goes dow n, so inspection can only b e carried out im mediately after t he engine is stopped.