24. SERVICE PROCEDURE Adjusting 1. Insert a bar between alternator 0 and the cylinder block to fix alternator 0 in position. When fixing alternator @I in position, insert a wooden block between the bar and alter- nator 0 to prevent damage to the alternator. 2. Loosen bolts and nuts 0 and 0. 3. Move alternator 0 with a bar so that the deflection of the belt is about 10 mm (approx. 6 kg). 4. Tighten the bolts and nuts @ and 0 to fix alternator @ in position. 5. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 6.
Replace belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on belt. 7. When the new belt is set, readjust it after operation for an hour. 24.5.6 CHECK ELECTRIC WIRINGS Check for damage of the fuse and any sign of disconnec- tion or short circuit in the electric wiring. Check also for loose terminals and tighten any loose parts. Check the following points carefully. l Battery l Starting motor l Alternator Please contact your Komatsu distributor for investigation and correction of the cause. Accumulation of flammable material (dead leaves, FA wARN'NGl twigs, grass, etc.) around the battery may cause fire, so always check and remove such material.
When carrying out walk-around checks or checks before start- ing, always check if there is any accumulation of flammable material around the battery, and remove such flammable material. 3-47