. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING The standard deflection between the air conditioner compressor pulley and crank pulley when pressed with a thumb (approx. 98 N (10 kg)) should be approx. 11 to 15 mm (0.4 to 0.6 in). When a belt tension gauge is used, the standard tension is within a range of 353 to 530 N (36 to 54 kg). the NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the 4 - 45 CHECK WHEN CHANGING TH E V-BELT The standard deflection be tween the air conditioner compresso r pulley and fan pulley when p ressed with a thumb (approx.
98 N (10 kg)) sho uld be approx. 8 to 11.5 mm (0.315 t o 0. 5 in). When a belt tension gaug e is used, the standard tension is wit hin a range of 530 to 745 N (5 REMARK When the belt has been re placed with a new part, a high tensio n is necessary, so the initial t ension is in the value given above. ADJUSTING 1. Loosen bolt (1), then lo (2), and move compre 2. Tighten bolt (1) and compressor (3) in posi osen the locknut of bolt (2), tighten b ssor (3) to adjust. the locknut of bolt (2) to hold t tion.
In case any of the following occurs, ask the Komatsu distributor in y territory to replace the belt • The fan belt has elongat • A cut or crack is found o • Slipping or creaking sou s with new ones. ed, leaving little allowance for adjustmen n the belt. nd is heard coming from the belt. , readjust it after one hour of operation. nd is heard coming from the belt. When the new V-belt is set