Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE PROCEDURE FOR BLEEDING AIR 1. Fill the fuel tank with fuel. 2. Insert the key in the starting switch and turn it to ON position (B). 3. Hold the key at the ON position (B) for 30 seconds, then return it to OFF position (A) and wait for 10 seconds. 4. Repeat the operations in Step 2 and Step 3 four times. 4 - 54 7. When installing, tighten until the packing surface contacts the seal sur face of the filter holder, then tight en it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fu el.

If the filter cartridge is too loose, fuel will also leak from the packing, so alw ays tighten the correct amount. 8. After completing replacement of fuel filter cartridge (1), bleed the "PROCEDURE FOR BLEEDING AIR (PAGE 4-54)". 9. After completing the air bleeding, start the engine and check that ther e is no leakage of fuel from the fi lter seal surface. If there is any leakage, check the tightening condition of the fi lter cartridge. If there is still fuel l eakage, repeat Steps 1 - 3 to remove the filter cartridge, then check the packin g surface for damage or embed ded dirt.

If any damage or embedded dirt is found, replace the cartridge with a new part and repeat Steps 4 - 8 t o install it. 5. Crank the engine with the starting motor (starting rotation of starting motor) and start the engine. high-pressure circuit. When the engine is cranked, the air is automatically bled from the If the engine does not start, the air has probably not been bled prope the procedure from Step 1. If the engine is operated with air remaining in the fuel circuit, an err the fuel system. If this happens, keep the throttle at Lo after starting the engine and 3 minutes.

When the air is bled and the engine rotation becomes stabilized, t When the engine is cranked, the air is automatically bled from the If the engine does not start, the air has probably not been bled prope rly from the low-pressure circuit. Repeat If the engine is operated with air remaining in the fuel circuit, an err or (CA449, CA559) may be gene rated in run the engine continuously for approx. he error display will go out.