. OPERATION MACHINE OPERATIONS AND CONTROLS Permissible Water Depth CAUTION TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such 3 - 75 When driving the machine out of w ater, if the angle of the machine exceeds 15°, the rear of the upper structu re will go under water, and water will be thrown up by the radiator fan. Thi s may cause the fan to break. the machine out of water. Be extremely careful when driving Do not immerse the machine i n water by more than the permissible depth (under center of carrier roller (1)).
been immersed in water for a long e old grease comes out from the pins) In addition, for parts that have time, pump in grease until th bearings. (Around the bucket operations. Itis particularly dangerous to s If such operations have to be c the slope so that the machine wing downhill when the bucket is loaded. arried out, pile soil to make a platform on can be kept horizontal when operating. Do not travel up or down steep slopes. There is danger that the machine may turn over. When traveling, raise the bucke t approx. 20 to 30 cm (8 to 12 in) from the ground. Do not travel downhill in rever se. across slopes.
Never turn on slopes or travel Always go down to a flat place longer, but it will ensure safety to perform these operations. It may be . Always operate or travel in suc h a way that it is possible to stop safely at any time if the machine slip s or becomes unstable. When traveling uphill, if the sh oes slip or it is impossible to travel uphill using only the force of the track to help the machine travel uphi turn over. s, do not use the pulling force of the arm ll. There is danger that the machine may