Komatsu — TRAVELING ON SLOPES

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS the work Traveling Downhill levers to the neutral position, lower the bucket to the 3 - 76 . Wh en traveling down stee p hills, use the travel leve r and fue con Wh eq an trol lever to keep the tr avel speed low. ep hill of more than 15°, set the wor shown in the diagram on the right d. en traveling down a ste uipment to the posture d lower the engine spee REMAR Travel If the m tends t K down fills with the sprocket (1) side down. achine travels down with the sprocket (1) side up, the trac o become loose, and that can cause skipping pitches. .

Wh uipment to the posture shown in the diagram on t Put the travel lever in the neut ral position. This will caus e the brake to b e automatically ap Engine Stopped on Slope If the engine stops when trav eling uphill, move the trav If the e ground , stop the machine, the n start the engine again. Cab Doors on Slope If the engine stops when th e machine is on a slope, n ever use the lef t work equipment c ontrol lever to carr y out swin g operations. The uppe r structure will swing unde r its own weigh t. Do n ot open or close the sli ding door (cab specificatio ns) on sl opes w hen traveling or o perating. The operating effor t may change suddenly . r locked.

Alwa ys keep the sliding doo Take good care when open ing or closing the sliding d oor (the cab sp ecification). There is the danger that it wil likel y gain momentum due t o its own weight and open or shut sudden ly.