. MAINTENANCE MAINTENANCE PROCEDURE Loosening Track Tension WARNING 4 - 30 Increasing Track Prepare a grea 1. Pump in gre ase through g rease fi tting (2) with a grease p ump. 2. To check if the tension is correct, run the engi ne at low i dling, move the m achine slowly forwar d (by an amo unt equal t o the length of tra ck on ground ), then s top the mach 3. Check the tr ack tension a gain, an d if t he tensio n is not correct, adjust it aga 4. Continue to pump in grea se until dimension S becomes zero (0) . If the tension is sti ll loose , th e pin an d bushing are excessively worn, so the y must be e ither turn ed or replaced. Please cont act your Kom atsu distributor for re pairs.
It is extremely da ngerous to relea se the g reas e by any m ethod exce pt the If the track tensio n is not relieved by this procedure, ple ase contact your Komatsu distributor for rep 1. Loosen plu g (1) gradually to release t he greas e. one turn. 2. When loose ning plug (1), turn it a maximum of one turn. 3. If the greas e does not co me out smoothly, mo ve the machine forwards an d backwards a short 4. Tighten plu 5. To check if the tension is correct, run the engi ne at low i dling, move the m achine slowly forwar d (by an amo unt equal t o the length of tra ck on ground ), then s top the mach ine. 6.
Check the tr ack tension a gain, an d if t he tensio n is not correct, adjust it aga in.